How to measure your ring finger size

1.Using a ruler:

1. Find a ring among your existing rings, that fits your finger snug, but not too tight.
2. Use ruler or measuring tape to measure the inner diameter of your ring. In order to do so, ensure you are using a ruler with millimetre (mm) measurements, then place your ring on top of the ruler and measure the inside of the circle – in other words, the inner diameter of the ring. Make sure you measuring the widest part of the inner diameter ( the one in contact with your finger )
3. Use  Ring Size Chart attached below to convert your diameter measurement into the correct ring size relevant to your country ( different countries use different finger size references)

 2. Measuring your finger size using paper or a piece of string:

1. Cut a piece of string or paper ( 2-3 mm wide strip ) to a length of around 10 centimetres (cm).
2. Strip of paper would give you more accurate measurement because of its width, similar to the width of the potential ring band.
3. Wrap the paper or string around your finger at the point where the ring should sit. Pull so that the string fits comfortably around your finger - not too tight and not too loose.
4. Use a pen to mark the point where the end of the string or paper overlaps itself.
5. Lay the string or paper out against a ruler or tape measure, and measure the length (mm) from its end to the point you have marked with pen.

6. Use it to find your size using our Ring Size Chart